Bruce Roberts Pilothouse
For Sale!

• 1992 Bruce Roberts custom pilothouse cutter. /descriptions/Roberts34'description.htm
• L.O.A. 34' 1''
• L.W.L. 28' 4"
• BEAM 11' 6"
• DRAFT 5' 6"
• SAIL AREA 621 sq ft
• BALLAST 6,500 lb (encapsulated iron)
• DISPLACEMENT 15,750 lb strenghtened for blue-water cruising,
• The engine (Westebeke 33hp 900 hours) runs reliably.
• Hull is solid fiberglass about one inch thick at the turn of the bilge and probably close to 2 inches below the full keel with its cut away forefoot.
• The boat has a very nice and spacious layout starting with a pullman berth double at the bow. Moving aft there are 2 settee berths on port and starboard, with a galley to starboard and enclosed head to port. The pilothouse (which has standing headroom and quite a lot of space) has a separate steering station (Edson wire steering system) and a hatch in the floor gives complete access to the engine. There is also a tiller in the cockpit, along with the sail control lines. This boat could be perfect as a liveaboard or a long distance cruiser.
• Lots of equipment including, 2 Schaeffer 2000 roller furling units (genny & staysail).
• Lewmar 30 self-tailing winches
• Solar panel
• Mainsail
• 135% Genny
• Staysail
• 8 opening ports and 2 opening hatches provide great ventilation
• 2 burner alcohol stove, stainless steel sink, huge icebox, hot and cold water.
• Stainless anchor roller.
• Marelon throughhulls.
• Deck stepped mast with steel compression post.
• Lots of work done in 2005: -Decks have been completely recored using West System epoxy, contourcore end grain balsa, and solid epoxy wherever hardware is throughbolted.
• New Tempo fuel tank, Racor fuel filter.
• New holding tank and waste water hoses
• Propeller reconditioned, new propeller strut, new cutless bearing. Propeller shaft checked for straightness.
• All new chainplates installed (U-bolt style) -all rigging professionally checked and replaced as needed (new forestay, new t-bolt toggles)
• New topsides paintjob \
• 3 coats of VIVID bottom paint
• Decks painted
• Rebuilt rudder -lots more
• These boats usually sell for $60,000-$90,000 on Yachtworld.com, and while this particular boat needs some work before it is perfect, it is still a great opportunity to get a lot of boat for your money.
  
• Location: Shippagan, New Brunswick

Asking $24,000.00